Our 2” hose and pipe ramp is designed to hold up to a Schedule 40 pipe, 2 ⅜” OD, however you could fit a 3” OD hose/pipe.
Our pipe ramp was engineered for the Yelomine™ and Aquamine® pipes, however our pipe ramp can fit up to a 5” pipe or hose.
Generally, they do not, but that depends on the application and your requirements. Just lay down and place your pipe or hose into the open slot. Our 2” pipe ramp weighs 36 pounds and our 4” pipe ramp set (2 ramps and our interconnector) weighs a total of 84 pounds each and are stabilized by the inserted pipe. If they need to be anchored in place, we recommend the GRK’s RSS™ Rugged Structural Screw.
There are no connector pieces, but they can be laid side-by-side in a row.
Our pipe ramps are extruded with EDPM rubber and are construction rated. They have been tested and used daily with large construction vehicles and large emergency vehicles.
No, the pipe or hose will need to be strong enough to hold the weight. Our ramps will disburse and hold the pipe in place as the vehicle rolls over the ramp and inserted pipe.
Our 4” pipe and hose ramp system consist of 2 ramps and one ramp interconnector piece that holds the 2 ramps together when the pipe or hose is inserted. The total weight of this ramp set is 84 pounds. The ramp pieces stay below the OSHA standard weight regulation for one man. These pieces easily fit together on-site and are ready for use in minutes.
We extrude both our 2” and 4” pipe and hose ramps in 36” (3’) sections. We can custom extrude up to 10’ if needed.
If your municipal project is in a mandated prevailing rate area, the first time you use our pipe ramps they will be paid for. Please email RubberForm (Sales@RubberForm.com) for our cost-justification spreadsheet so you can convince your municipality and or your team to use the RubberForm pipe ramp system.