- Parking Lot Safety
- Public Sector
SB-10 SPEED BUMP
Product Description
Our RubberForm SB-10 Speed Bumps are effective permanent or temporary traffic calming devices, ideal for reducing vehicle speeds under 10 miles per hour. They’re easy to install, easy to relocate, and highly visible day or night. Our speed bump’s 100% American recycled composite material won’t crack, crumble, or corrode, with thermoplastic, glass beaded reflective arrows no matter the heat, cold, rain, ice, or snow you throw at it.
Don’t Forget the Installation Hardware
Specifications:
- Each 24” speed bump module is
- SB-10 End unit – 4.1 lbs
- SB-10 Center unit – 5.75 lbs
- 24″L x 10″W x 2-1/4″H
- Easy to deploy, install, and recover
- High visibility, thermoplastic yellow or white, glass beaded reflective safety arrows
- Install on any asphalt or concrete surface with four anchoring points per module
- All-weather durability – will not warp, chip, crack, spall, or corrode
- Made in the USA with 100% American recycled composite material
Product Description
Most traffic calming methods are a huge pain. Concrete and asphalt speed bumps are difficult and time-consuming to install. They’re even harder to remove later when your needs change. They’re ugly, and when they chip, crack, and crumble (and they will), they stop working well–and somehow get uglier.
RubberForm SB-10 Speed Bumps are blessedly easy and convenient. They’re simple to install and just as easy to remove or relocate later. Their thermoplastic reflective safety arrows maintain high visibility at night, in fog, rain, or snow. They’re made to slow vehicle traffic below 10 miles per hour for pedestrian safety.
Our speed bumps are carefully innovated to withstand every possible environment you might want to install them in. They won’t melt in the searing summer sun or shatter in the frigid cold. They’re unaffected by rain, ice, or snow. Our 100% American recycled rubber won’t chip, warp, or spall either.
Models
RF-SB10E
- SB-10 Speed Bump End Module
- Two – Thermoplastic Safety yellow or white arrows
- 4.1 lbs
- 24″L x 10″W x 2-1/4″H
RF-SB10C
- SB-10 Speed Bump Center Module
- Two – Thermoplastic Safety yellow or white arrows
- 5.75 lbs
- 24″L x 10″W x 2-1/4″H
Key Features
- Easy to deploy, install, and recover
- High visibility safety arrows
- Install on any asphalt or concrete surface
- All-weather durability – will not warp, chip, crack, spall, or corrode
- Made in the USA with 100% American recycled rubber/ plastic composite material
Hardware Kits
RF-SB10HWK – included with every section
- 4 – Hex Lag Screws – Steel: 1/2”W x 4”L
- 4 – Plastic Shield for Lag Screw: 3″L x 5/8″W
- 4 – Flat Washers: 1/2”W x 1-1/16”L
- 1 – Dual Flange Connector
FROM ONE SPECIALIST TO ANOTHER
Related products
Whether you need speed bumps, roofing support, curb ramps, or more, RubberForm specializes in safety and risk mitigation.
